Metrohm 746 VA Trace Analyzer - Manual (Page 319)

5.6 Method Specifications
746 VA Trace Analyzer / 747 VA Stand
5-168
Parameter Range; Default value / Meaning
Method Method name
Title Method title
Remark 1 Remark 1 regarding method
Remark 2 Remark 2 regarding method
The following reports can be selected:
Report Short Short report with Final results which have
been defined on the "CALCULATIONS" page. This
report is identical with the subpage "Calculations"
(see section 5.5.2).
Report Eval Evaluation report with detailed results of the peak
or wave evaluation for all substances. This report
is identical with the subpage "Evaluations" (see
section 5.5.2).
Report Full Full report with the following outputs:
− Detailed results of the peak or wave evaluation
for all substances (subpage "Evaluations", see
section 5.5.2)
− Results of all substance calibrations (subpage
"Calibrations", see section 5.5.2)
− Solutions (dialog page "SOLUTIONS", see
section 5.3.4)
− Common variables (dialog page "COMMON
VARIABLES", see section 5.4.5)
− Final results (subpage "Calculations", see sec-
tion 5.5.2)
Report MethSpc Method report with output of all dialog pages of
the group "Method Specifications":
− Dialog page "OPERATION SEQUENCE"
− Dialog page "SEGMENTS" (all segments)
− Dialog page "DOCUMENTATION"
− Dialog page "SUBSTANCES" (all substances)
− Dialog page "CALCULATION"
Report Mpts Measured point report with output of the list of
measured points of segments. It is necessary to
enter the name of the substance or segment and
the VR number:
Sbst: Output of the original measured values of the
segment associated with the specified substance.
Sgmt: Output of the original measured values of the
specified segment.
VR: xx Selection of the single measurement whose list of
measured points should be put out by specifica-
tion of the VR number (V = variation, R = replica-
tion). On entry of
* , all variations or replications
are put out.