Metrohm 746 VA Trace Analyzer User Manual

Page 186

5.3.2 STAND

746 VA Trace Analyzer / 747 VA Stand

5-35

Rack name: XXXXXXXX 695 AUTOSAMPLER Valid entries: XXX

Rack type: XXXXXXXX Rack definition V.sample max : XXXXX mL

Rack pos. X-pos./mm Y-pos./mm Z-pos./mm Speed

ДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДД

XXX XXXXXXX XXXXXXX XXXXXXX XXXXXXX

Down

Specifying positions in the teach mode

Move position in x direction

The needle tip is moved to the desired x position using the cursor
keys <ç> or <è>. The current x position is shown in the
window.

Move position in y direction

The needle tip is moved to the desired x position using the cursor
keys <é> or <ê>. The current y position is shown in the win-
dow.

Down

Move position in z direction

The needle tip is moved to the desired z position using these two
softkeys. The current z position is shown in the window.

When shifting the position with the cursor keys or the softkeys

and

, the following applies:

Each time these keys are pressed, the needle position is
shifted by 0.125 mm (x and y axis) or 0.05 mm (z axis) in
the selected direction. In contrast to the softkeys, the cur-
sor keys are repetitive, i.e. the longer the cursor key is
pressed, the further the needle is shifted.

ENTER

Adopt position

When the desired position is reached, it is adopted definitively by
pressing the key. The needle is then automatically
raised to the position z = 0 mm.

ESC

ЪДДД

ДДД

Wait ДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДД

ДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДД¿

Learning position: XXX

X=XXXXXX Y=XXXXXX Z=XXXXXX

АДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДД

ДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДДЩ