Configuring ac 1 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 838
817
Configuring AC 1
1.
Configure AC 1 to support link backup between AC and AP to make sure traffic can be switched
to AC 2 when AC 1 fails:
a.
From the navigation tree, select Advanced > AC Backup.
The default Setup page appears.
b.
Select IPv4 and enter the IPv4 address of AC 2 (8.190.1.61) as the backup AC address, and
select Enable from the Fast Backup Mode list.
c.
Click Apply.
Figure 868 Setup page
2.
Configure stateful failover:
a.
Select High reliability > Stateful Failover from the navigation tree.
b.
Select Enable Stateful Failover, select Unsupport Asymmetric Path from the Backup Type list,
enter 2 for Backup VLAN, and select 1 for NAS Device ID.
c.
Click Apply.
Figure 869 Configuring stateful failover
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module