Configuring rate limit – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 681

660
Item
Description
TCP/UDP
Port
Source
Operator
Select the operators, and enter the source port numbers and
destination port numbers as required.
These items are available only when you select 6 TCP or 17 UDP
from the Protocol list.
Different operators have different configuration requirements for the
port number fields:
•
Not Check—The following port number fields cannot be
configured.
•
Range—The following port number fields must be configured to
define a port range.
•
Other values—The first port number field must be configured
and the second must not.
Port
To Port
Destination
Operator
Port
Port
Time Range
Select the time range during which the rule takes effect.
Configuring rate limit
Rate limit uses token buckets to control traffic. The rate limit of a physical interface specifies the maximum
rate for forwarding packets (including critical packets). Rate limit can limit all the packets passing a
physical interface.
To configure rate limit:
1.
Select QoS > Line rate from the navigation tree.
2.
Click the Setup tab.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module