H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 149)

128
Item Description
Access Level
Set the access level for a user. Users of different levels can perform different operations.
The following Web user levels, from low to high, are available:.
• Visitor—Users of this level can perform the ping and traceroute operations, but they
cannot access the device data or configure the device.
• Monitor—Users of this level can only access the device data but cannot configure the
device.
• Configure—Users of this level can access data on the device and configure the
device, but they cannot upgrade the host software, add/delete/modify users, or back
up/restore the application file.
• Management—Users of this level can perform any operations on the device.
Password Set the password for a user.
Confirm Password
Enter the same password again. Otherwise, the system prompts that the two passwords
are not consistent when you apply the configuration.
Passsword
Encryption
Set the encryption method for storing users' passwords:
• Reversible—The device stores passwords by using reversible encryption.
• Irreversible—The device stores passwords by using irreversible encryption.
Service Type
Set the service type, including Web, FTP, and Telnet services. You must select at least
one service type.
Setting the super password
Management level users can specify the password for a lower-level user to switch from the current access
level to the management level. If this password is not configured, the switchover will fail.
To set the super password:
1. Select Device > Users from the navigation tree.
2. Click the Super Password tab.
The super password configuration page appears.
Figure 85 Setting the super password
3. Set the super password as described in Table 50 .