Pppoe client configuration example, Network requirements, Figure 225 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 271: Ribed in, Table 94
250
Figure 225 Summary
Table 94 Field description
Field Description
Session Number
PPPoE session ID.
Dialer Interface
Number
Number of the dialer interface corresponding to the PPPoE session.
Interface
Ethernet interface where the PPPoE session belongs. This field is null when the PPPoE
session is bundled with a VLAN interface.
Client-MAC
MAC address of the PPPoE client.
Server-MAC
MAC address of the PPPoE server.
Status
PPPoE session state:
•
IDLE—PPPoE client negotiation is not performed.
•
PADI—PADI packets have been sent. The interface is waiting for the PADO
response.
•
PADR—PADR packets have been sent. The interface is waiting for the PADS
response.
•
PPPNEG—PPP negotiation is started.
•
PPPUP—PPP negotiation is completed.
PPPoE client configuration example
Network requirements
Configure PPPoE client on the AC and enable the PPPoE client to communicate with the PPPoE server, as
shown in
.
Figure 226 Network diagram
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module