H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 345
324
Figure 308 Binding an AP
e.
Select AP > AP Setup from the navigation tree. You can see that the AP is in IDLE state.
Figure 309 AP status before auto AP is enabled
5.
Enable 802.11gn radio:
a.
Select Radio > Radio Setup from the navigation tree.
b.
Select the box to the left of the target AP.
c.
Click Enable.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module