Configuring load balancing, Configuration prerequisites – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 756
735
Figure 766 Testing busy rate of channels
3.
Configure channel busy test as described in
4.
Click Start to start the testing.
Table 244 Configuration items
Item Description
AP Name
Display the AP name.
Radio Unit
Display the radio unit of the AP.
Radio Mode
Display the radio mode of the AP.
Test Time Per Channel
Set a time period in seconds within which a channel is tested.
NOTE:
•
During a channel busy test, the AP does not provide any WLAN services. All the connected clients are
disconnected.
•
Before the channel busy test completes, do not start another test for the same channel.
Configuring load balancing
Band navigation and load balancing can be used simultaneously.
Configuration prerequisites
Before you configure load balancing, verify that:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module