Verifying the configuration, Ap version upgrade configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 806

785
3.
Configure a load balancing group:
a.
Select Advanced > Load Balance from the navigation tree.
b.
Click the Load Balance Group tab.
c.
Click Add.
d.
On the page that appears, select ap1. radio 2 and ap2. radio 2 in the Radios Available area,
click << to add them to the Radios Selected area, and click Apply.
Figure 820 Configuring a load balancing group
Verifying the configuration
•
Radio 2 of AP 1 and radio 2 of AP 2 are in the same load balancing group, and the radio of AP
3 does not belong to any load balancing groups. Because load balancing takes effect only on
radios in a load balancing group, AP 3 does not take part in load balancing.
•
Assume Client 3 wants to associate with AP 1. Because the maximum traffic threshold and traffic
gap have been reached on radio 2 of AP 1, Client 3 is associated with AP 2.
AP version upgrade configuration example
Network requirements
As shown in
, configure the AP version upgrade function to upgrade the AC, AP 1 and AP 2.
The AC has established an LWAPP tunnel with AP 1, AP 2 and AP 3, respectively.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module