Figure 264 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 307
286
Figure 264 Adding basic ACL
e.
Click the Basic Setup tab.
f.
Select 2001 for ACL.
g.
Select Permit for Action, as shown in
.
h.
Click Apply.
Figure 265 Configuring a rule for basic ACL
3.
Configure the NAT address pool:
a.
Select Network > NAT from the navigation tree.
The Dynamic NAT page appears.
b.
Click Add in the Address Pool area.
The Add NAT Address Pool page appears.
c.
Enter 1 for Index.
d.
Enter 5.5.5.9 for Start IP Address.
e.
Enter 5.5.5.11 for End IP Address.
f.
Click Apply.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module