Setting edca parameters for wireless clients, Configuration restrictions and guidelines, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 715
694
Access category
TXOP Limit
AIFSN
ECWmin
ECWmax
AC-BE 0
3
4
6
AC-VI 94 1 3
4
AC-VO
47
1
2
3
NOTE:
•
ECWmin cannot be greater than ECWmax.
•
On an AP operating in 802.11b radio mode, HP recommends that you set the TXOP-Limit to 0, 0, 188,
and 102 for AC-BK, AC-BE, AC-VI, and AC-VO.
Setting EDCA parameters for wireless clients
Configuration restrictions and guidelines
Follow these restrictions and guidelines when you set EDCA parameters for wireless clients:
•
ECWmin cannot be greater than ECWmax.
•
If all clients operate in 802.11b radio mode, set TXOPLimit to 188 and 102 for AC-VI and AC-VO.
•
If some clients operate in 802.11b radio mode and some clients operate in 802.11g radio mode in
the network, HP recommends the TXOPLimit parameters in
•
Once you enable CAC for an access category, it is enabled automatically for all higher priority
access categories. For example, if you enable CAC for AC-VI, CAC is also enabled for AC-VO.
However, enabling CAC for AC-VO does not enable CAC for AC-VI.
Configuration procedure
1.
Select QoS > Wireless QoS from the navigation tree.
By default, the Wireless QoS tab is displayed.
2.
Click the icon in the Operation column for the desired AP.
3.
On the client EDCA list, click the icon in the Operation column for the desired priority type
(AC_BK, for example).
Figure 722 Setting client EDCA parameters
4.
Configure the client EDCA parameters, as described in
.
5.
Click Apply.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module