Verifying the configuration, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 802
781
Figure 814 Setting traffic-mode load balancing
Verifying the configuration
Client 1 and Client 2 are associated with AP 1. Add Client 3 to the network. When the maximum traffic
threshold and traffic gap are reached on AP 1, Client 3 is associated with AP 2.
Group-based session-mode load balancing configuration
example
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 is associated with AP 1. Client
2 through Client 6 are associated with AP 2, and no client is associated with AP 3.
•
Configure session-mode load balancing on the AC. The maximum number of sessions is 5, and the
maximum session gap is 4.
•
Session-mode load balancing is required on only radio 2 of AP 1 and radio 2 of AP 2. Therefore,
add them to a load balancing group.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module