Verifying the configuration, Automatic power adjustment configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 531
510
3.
Perform manual channel adjustment:
a.
Select Radio > Calibration from the navigation tree.
b.
On the Operation tab, select the box of the target radio.
c.
Click Channel Optimize.
Figure 543 Performing manual channel adjustment
Verifying the configuration
•
You can view the channel status on the Operation tab you enter by selecting Radio > Calibration
from the navigation tree.
•
After you perform manual channel calibration, the AC informs the adjusted channel to the AP after
a calibration interval.
•
You can view the detailed information, such as the specific reason for channel adjustment on the
History Info tab you enter by selecting Radio > Calibration from the navigation tree, clicking
Operation, and then clicking History Info.
Automatic power adjustment configuration
example
Network requirements
As shown in
, AP 1 through AP 3 are connected to the AC. Configure automatic power
adjustment and specify the adjacency factor as 3 on the AC. In this way, when AP 4 joins, the AC
performs automatic power adjustment to avoid interference.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module