H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 37)

16
Feature matrix for the WX3000E series
The access controller engine and switching engine of the WX3000E series adopt the OAA architecture.
The switching engine is integrated on the access controller engine as OAP software. You actually log in
to the access controller engine when you log in to the switch by default.
H3C recommends not configuring QoS rate limiting or 802.1X authentication on the internal aggregate
interfaces (BAGG1) between the switching engine and the access controller engine on a WX3000E
series wireless switch. Inappropriate rate limiting or authentication settings on the internal aggregate
interfaces can cause communication problems between the switching engine and the access controller
engine. On a WX3024E wireless switch, the switching engine's internal aggregate interface is formed
by GigabitEthernet 1/0/29 and GigabitEthernet 1/0/30. On a WX3010E wireless switch, the
switching engine's internal aggregate interface is formed by GigabitEthernet 1/0/10 and
GigabitEthernet 1/0/11. On all WX3000E switches, the access controller engine's internal aggregate
interface is formed by GigabitEthernet 1/0/1 and GigabitEthernet 1/0/2.
For configuration information about the switching engine of the WX3000E series, see H3C WX3000E
Series Wireless Switch Switching Engine Configuration Guide and H3C WX3000E Series Wireless
Switch Switching Engine Command Reference.
Table 7 Feature matrix for the WX3000E series
Module Feature WX3024E WX3010E
Device
License
manageme
nt
License
management
No. No.
Enhanced
license
management
Supports IAA and RFP.
Supports configuring the
numbers of APs and sensors
(WIPS).
Supports 24 concurrent APs
and 0 concurrent sensors by
default, and can be extended
to support 96 concurrent APs
and 96 concurrent sensors.
Supports IAA and RFP.
Supports configuring the
numbers of APs and sensors
(WIPS).
Supports 12 concurrent APs
and 0 concurrent sensors by
default, and can be extended to
support 36 concurrent APs and
36 concurrent sensors.
Configuration management
Supports backing up .cfg
files.
Supports backing up .cfg files.
File management Flash supported. CF supported.
Port mirroring No. No.
Loopback test
Internal loopback testing
supported on GE interfaces
only. Internal loopback testing
supported on GE interfaces
only.
OAP management Yes. Yes.
Network
IGMP snooping
The maximum number of
multicast groups is in the
range of 1 to 64 and defaults
to 64.
The maximum number of
multicast groups is in the range
of 1 to 64 and defaults to 64.
Link aggregation and LACP No. No.
DDNS Yes. Yes.
PPPoE Yes. Yes.