H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 763)

742
Table 250 Configuration items
Item Description
Location Function
• Enable—Enable the wireless location function. The device begins to listen to
packets when wireless location is enabled.
• Disable—Disable wireless location.
To ensure the location function, complete the configuration on the location server
and AC:
• On the location server—Configure whether to locate Tags or MUs, Tag
message multicast address, and dilution factor on the location server. These
settings will be notified to the APs through the configuration message. For more
information about location server and configuration parameters, see the
location server manuals.
• On the AC—Configure the AP mode settings, and enable the wireless location
function.
When configurations are made correctly, APs wait for the configuration message
sent by the location server. After receiving that message, the APs start to receive
and report Tag and MU messages.
Protocol Type
Specify a wireless location protocol.
• Aero Scout—Use the AeroScout protocol.
• General—Use the general location protocol.
General Mode Specify a wireless location general mode: Fingerprint or CUPID.
Address Acquisition
Method
Specify a wireless location method.
• Static—Apply the static location mode.
• Dynamic—Apply the dynamic location mode.
Vendor Port
Set the vendor port number in the XML file on the AeroScout location server, in the
range of 0 to 65535. By default, the port number is 1144.
Ignored Frame Type Ignore beacon frames.
RSSI Threshold Specify the RSSI threshold for the location packets, in the range of 5 to 100.
AP Rate Limit
Configure the following rates for the AP:
• CIR—Specify the CIR for the location packets from the AP, in the range of 8 to
1300000 Kbps.
• CBS—Specify the CBS for the location packets from the AP, in the range of 500
to 130000000 bytes.
Client Rate Limit
Configure the following rates for the clients:
• CIR—Specify the CIR for the location packets from the clients, in the range of 1
to 1300000 Kbps.
• CBS—Specify the CBS for the location packets from the clients, in the range of
80 to 130000000 bytes.
AP Report AP reporting status: Enable or Disable.
AP Report Interval Set the AP reporting interval in the range of 1 to 10 seconds.
Address Configuration
Specify the view in which the IP address of the location server is configured.
• AP Group Table—Configure the IP address of the location server in AP group
view.
• AP Table—Configure the IP address of the location server in AP template view.
Dilution Factor Specify the dilution factor for the location packets, in the range of 1 to 10000.