Ipv6 static route configuration example, Network requirements, Configuration outlines – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 215: Configuration procedure
194
IPv6 static route configuration example
Network requirements
The IP addresses of devices are shown in
. IPv6 static routes must be configured on Switch A,
Switch B and AC for Host A and Host B to communicate with each other.
Figure 164 Network diagram
Configuration outlines
1.
On Switch A, configure a default route with Switch B as the next hop.
2.
On Switch B, configure one static route with Switch A as the next hop and the other with AC as the
next hop.
3.
On AC, configure a default route with Switch B as the next hop.
Configuration procedure
1.
Configure a default route with the next hop address 4::2 on Switch A.
2.
Configure two static routes on Switch B: one with destination address 1::/64 and next hop
address 4::1, and the other with destination address 3::/64 and next hop address 5::1.
3.
Configure a default route on AC:
a.
Select Network > IPv6 Routing from the navigation tree.
b.
Click the Create tab.
The IPv6 static route configuration page appears, as shown in
c.
Enter :: for Destination IP Address, select 0 for Prefix Length, and enter 5::2 for Next Hop.
d.
Click Apply.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module