Configuring a channel busy test, Figure 485 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 755
734
Figure 764 Transmission rate (802.11ac)
3.
Click Apply.
4.
To stop the continuous transmitting mode:
Click the
icon for the target radio.
Or, select the target radio and click Stop.
After the continuous transmit is stopped, the transmission rate value on the page shown in
is displayed as 0.
NOTE:
When continuous transmit is enabled, do not perform any operations other than transmission rate
configuration.
Configuring a channel busy test
1.
Select Advanced > Channel Busy Test from the navigation tree.
Figure 765 Configuring a channel busy test
2.
Click the
icon for the target AP.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module