Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 798
777
Figure 810 Displaying the client status on AC 2
This page shows that the client is in Running(Backup) state, which means the client is
associated with the backup AC AC 2.
c.
Display roam-track information of the clients (select Summary > Client from the navigation tree,
click the Roam Information tab, and select the target client to view its detailed roaming
information. If the information on the two ACs is consistent, the client roaming information has
been synchronized.
2.
When AC 1 fails, AC 2 becomes the primary AC. During the switchover, clients are not logged off
and can access network through AC 2.
AP-based session-mode load balancing configuration example
Network requirements
•
As shown in
, all APs operate in 802.11g mode. Client 1 is associated with AP 1. Client
2 through Client 6 are associated with AP 2.
•
Configure session-mode load balancing on the AC. The threshold (the maximum number of sessions)
is 5, and the session gap is 4.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module