Configuring the pppoe client, Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 272
251
Configuring the PPPoE client
1.
Configure the PPPoE client:
a.
Select Network > PPPoE from the navigation tree.
The system automatically enters the Client page.
b.
Click Add.
The page for creating a PPPoE client appears, as shown in
.
c.
Enter 1 as the dialer interface name.
d.
Enter user1 as the username.
e.
Enter hello as the password.
f.
Select PPP Negotiate for IP config.
g.
Select Vlan-interface1 for Bundled Interface.
h.
Select Always Online for Session Type.
i.
Click Apply.
Figure 227 Creating a PPPoE client
2.
Configure the PPPoE server:
You must enable the PPPoE protocol on the PPPoE server, configure the PPPoE username and
password that are the same as those configured on the PPPoE client, and assign an IP address to
the peer end of the PPP connection. (Details not shown.)
Verifying the configuration
To display the summary information of the PPPoE session on an AC:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module