Configuring ac 2 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 790

769
Figure 799 Configuring the IP address of the backup AC
Configuring AC 2
1.
Configure AP to establish a connection between AC 2 and AP.
For more information about configurations, see "
."
2.
Leave the default value of the AP connection priority unchanged. (Details not shown.)
3.
Select Advanced > AC Backup from the navigation tree.
4.
On the page that appears, select the IPv4 box, set the address of the backup AC to 1.1.1.4, and
select enable to enable the fast backup mode.
5.
Click Apply.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module