H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 682
661
Figure 692 Configuring rate limit on a port
3.
Configure rate limit, as described in
4.
Click Apply.
Table 217 Configuration items
Item
Description
Please select an interface type
Select the types of interfaces to be configured with rate limit.
The interface types available for selection depend on your device model.
Rate Limit
Select Enable or Disable to enable or disable rate limit on the specified port.
Direction
Select a direction to which the rate limit is to be applied:
•
Inbound—Limits the rate of packets received by the specified port.
•
Outbound—Limits the rate of packets sent by the specified port.
CIR
Set the committed information rate (CIR), the average traffic rate.
CBS
Set the committed burst size (CBS), number of bits that can be sent in each
interval.
EBS
Set the excess burst size (EBS).
This configuration item is not supported.
Please select port(s)
Specify the ports to be configured with rate limit.
Click the ports to be configured with rate limit in the port list. You can select
one or more ports.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module