Configuring whitelist, Rogue detection configuration example, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 647
626
Configuring whitelist
1.
Select Security > Filter from the navigation tree.
2.
Click the Whitelist tab.
Figure 665 Configuring a whitelist
3.
Click Add.
Figure 666 Adding a whitelist
4.
Add a whitelist as described in
Table 202 Configuration items
Item Description
MAC Address
Select MAC Address, and then add a MAC address to the whitelist.
Select from Connected
Clients
If you select the option, the table below this option lists the current existing
clients. Select the options of the clients to add their MAC addresses to the
whitelist.
5.
Click Apply.
Rogue detection configuration example
Network requirements
As shown in
, a monitor AP (AP 2 with serial ID SZ001) and AP 1 (serial ID SZ002) are
connected to an AC through a Layer 2 switch.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module