beautypg.com

Table 22 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual

Page 83

background image

62

Table 22 Field description

Field Description

Service Template Number

Service template number.

SSID

Service set identifier (SSID) for the ESS.

Description

Description for the service template. If no description is configured, this field
displays Not Configured.

Binding Interface

Name of the interface bound with the service template.

Hotspot policy

Name of the hotspot policy applied to the service template.

Service Template Type

Service template type.

Authentication Method

Type of authentication used.
WLAN service of the clear type only uses open system authentication.

Authentication Mode

Authentication mode:

Central—Uses AC central authentication.

Local—Uses AP local authentication.

Backup—Uses backup authentication.

Beacon-measurement

Enable—Enables beacon measurement.

Beacon-measurement Interval

Intervals (in seconds) at which beacon measurement requests are sent.

Beacon-measurement Type

Beacon measurement type: Passive, Active, or Beacon-table.

SSID-hide

Disable—The SSID is advertised in beacon frames.

Enable—Disables the advertisement of the SSID in beacon frames.

Forwarding Method

Forwarding mode:

Policy-based forwarding.

Remote forwarding.

Local forwarding.

Packet Format

Packet format:

Dot11—802.11 format.

Dot3—802.3 format.

PMF Status

Status of management frame protection:

Disable—Management frame protection is disabled.

Optional—Management frame protection is enabled and all clients can

be associated with the AP.

Mandatory—Management frame protection is enabled and only clients

supporting management frame protection can be associated with the AP.

Service Template Status

Status of service template:

Enable—Enables WLAN service.

Disable—Disables WLAN service.

Maximum clients per BSS

Maximum number of associated clients per BSS.

IP Verify Source

Status of IPv4 source address verification:

Enable—Verifies the source address of an IPv4 client.

Disable—Does not verify the source address of an IPv4 client.