Table 44 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 135
114
Table 44 Configuration items
Item Description
Port State
Enable or disable the interface.
In some cases, modification to the interface parameters does not take effect
immediately. You need to shut down and then bring up the interface to make the
modification take effect.
Speed
Set the transmission rate of the interface.
Available options include:
•
10—10 Mbps.
•
100—100 Mbps.
•
1000—1000 Mbps.
•
Auto—Auto-negotiation.
•
Auto 10—The auto-negotiation rate of the interface is 10 Mbps.
•
Auto 100—The auto-negotiation rate of the interface is 100 Mbps.
•
Auto 1000—The auto-negotiation rate of the interface is 1000 Mbps.
•
Auto 10 100—The auto-negotiation rate of the interface is 10 Mbps or 100
Mbps.
•
Auto 10 1000—The auto-negotiation rate of the interface is 10 Mbps or 1000
Mbps.
•
Auto 100 1000—The auto-negotiation rate of the interface is 100 Mbps or 1000
Mbps.
•
Auto 10 100 1000—The auto-negotiation rate of the interface is 10 Mbps, 100
Mbps or 1000 Mbps.
Duplex
Set the duplex mode of the interface.
•
Auto—Auto-negotiation.
•
Full—Full duplex.
•
Half—Half duplex.
Link Type
Set the link type of the current interface, which can be access, hybrid, or trunk. For
more information, see
IMPORTANT:
To change the link type of a port from trunk to hybrid or vice versa, you must first set
its link type to access.
PVID
Set the default VLAN ID of the hybrid or trunk port.
IMPORTANT:
The trunk ports at the two ends of a link must have the same PVID.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module