H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 589)

568
Item Description
Accounting-On Interval
Set the interval for sending accounting-on packets. This field is
configurable only when the Send accounting-on packets option is selected.
Accounting-On Attempts
Set the maximum number of accounting-on packets transmission attempts.
This field is configurable only when the Send accounting-on packets option
is selected.
Attribute
Interpretation Enable or disable the device to interpret the RADIUS class attribute as CAR
parameters.
7. In the RADIUS Server Configuration area, click Add.
Figure 592 RADIUS server configuration page
8. Configure a RADIUS server for the RADIUS scheme.
Table 184 Configuration items
Item Description
Server Type
Select the type of the RADIUS server to be configured. Possible values include
primary authentication server, primary accounting server, secondary
authentication server, and secondary accounting server.
IP Address
Specify the IPv4 or IPv6 address of the RADIUS server.
You cannot specify the same server to serve as both the primary and the
secondary authentication server in the scheme. The same rule applies to the
primary and secondary accounting servers.
Make sure all RADIUS server addresses in the scheme use the same IP version.
Port Specify the UDP port of the RADIUS server.
Key
Confirm Key
Specify the shared key for communication with the RADIUS server.
If no shared key is specified here, the shared key specified in the common
configuration area is used.
9. Click Apply to add the server to the RADIUS scheme.
10. Repeat step 7 through step 9 to add more RADIUS servers to the RADIUS scheme.
11. On the RADIUS scheme configuration page, click Apply.