Verifying the configuration, Network requirements – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 726
705
7.
Enable CAC for AC_VI in the same way. (Details not shown.)
8.
Select QoS > Wireless QoS from the navigation tree.
By default, the Wireless QoS tab is displayed.
9.
Click the icon in the Operation column for the desired AP.
10.
Select the Client Number option, and then enter 10.
11.
Click Apply.
Figure 734 Setting CAC client number
Verifying the configuration
If the number of existing clients in the high-priority access categories plus the number of clients requesting
for high-priority access categories is smaller than or equal to the user-defined maximum number of users
allowed in high-priority access categories (10 in this example) the request is allowed. Otherwise, the
request is rejected.
Wireless service-based static rate limiting
configuration example
Network requirements
As shown in
, two wireless clients access the WLAN through a SSID named service1.
Limit the maximum bandwidth per wireless client to 1024 kbps for traffic from the wireless clients to the
AP.
Figure 735 Network diagram
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module