H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 728)

707
Figure 737 Network diagram
Configuring the wireless service
For the configuration procedure, see " Configuring access services ."
Configuring dynamic rate limiting
1. Select QoS > Wireless QoS from the navigation tree.
2. Click Client Rate Limit.
3. Select service2 from the Wireless Service list, select Inbound from the Direction list, and click .
4. Configure dynamic rate limiting:
a. Select Dynamic from the Mode list.
b. Enter 8000 in the Total Rate field.
5. Click Apply.
Figure 738 Configuring dynamic rate limiting
Verifying the configuration
Verify that:
1. When only Client 1 accesses the WLAN through SSID service2, its traffic can pass through at a
rate as high as 8000 kbps.
2. When both Client 1 and Client 2 access the WLAN through SSID service2, their traffic flows can
each pass through at a rate as high as 4000 kbps.