H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 478)

457
Configuring mesh point-to-multipoint
Mesh configuration in this example is the same as normal WLAN mesh configuration. For more
information, see " Configuring the AC ."
Mesh DFS configuration example
Network requirements
• As shown in Figure 214 , establish an 802.11n(5GHz) mesh link between the MAP and MPP. The
working channel is automatically selected.
• Enable one-time DFS. After that, the AC performs DFS for the radios when certain trigger conditions
are met on the channel.
Figure 493 Network diagram
Configuration guidelines
The mesh configuration in this example is similar to a common wireless mesh configuration. Follow these
guidelines when you configure mesh DFS:
• Configure the working channel mode of the radios that provide mesh services as auto.
• Do not configure any wireless service on radios that provide mesh services.
Configuration procedure
The mesh configuration is the same as the normal WLAN mesh configuration. For configuration
procedures, see "
WLAN mesh configuration example ." Perform the following operations after
completing mesh configuration:
1. (Optional) Set a calibration interval:
a. Select Radio > Calibration from the navigation tree.
b. Click the Parameters tab.
c. On the page that appears, enter the calibration interval 3 and click OK.
AC MPP MAP
802.11n(5GHz)