Manual, Auto – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 468

447
Manual
1.
Select Radio > Radio from the navigation tree, and click the
icon for the target AP.
Figure 475 Configuring a radio
2.
On the page that appears, select a specified channel from the Channel list.
3.
Click Apply.
NOTE:
Specify a working channel for the radios of the MAP and MPP. Specify the same working channel for the
radio of the MAP and the radio of the MPP.
Auto
Set the working channel mode on the MPP and MAP to auto so that the working channel is automatically
negotiated when a WDS link is established between the MPP and MAP.
NOTE:
If you configure the working channel mode of the radios of the MPP and MAP as auto, the automatically
selected working channel is a non-radar channel.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module