Link aggregation and lacp configuration example, Network requirements, Configuration procedure – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 250

229
Link aggregation and LACP configuration example
Network requirements
As shown in
, aggregate the ports on each device to form a link aggregation group,
balancing incoming/outgoing traffic across the member ports.
Figure 198 Network diagram
Configuration procedure
You can create a static or dynamic link aggregation group to achieve load balancing.
Method 1: Create a static link aggregation group
1.
From the navigation tree, select Network > Link Aggregation.
2.
Click Create.
3.
Configure static link aggregation group 1:
a.
Enter link aggregation interface ID 1.
b.
Select the Static (LACP Disabled) option for the aggregate interface type.
c.
Select GigabitEthernet 1/0/1, GigabitEthernet 1/0/2, and GigabitEthernet 1/0/3.
4.
Click Apply.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module