Configuring snmp trap function – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 160

139
Item Description
Group Name
Select an SNMP group to which the user belongs.
•
When the security level is NoAuth/NoPriv, you can select an SNMP
group with no authentication no privacy.
•
When the security level is Auth/NoPriv, you can select an SNMP
group with no authentication no privacy or authentication without
privacy.
•
When the security level is Auth/Priv, you can select an SNMP group of
any security level.
Authentication Mode
Select an authentication mode (including MD5 and SHA) when the
security level is Auth/NoPriv or Auth/Priv.
Authentication Password
Set the authentication password when the security level is Auth/NoPriv or
Auth/Priv.
The confirm authentication password must be the same as the
authentication password.
Confirm Authentication Password
Privacy Mode
Select a privacy mode (including DES56, AES128, and 3DES) when the
security level is Auth/Priv.
Privacy Password
Set the privacy password when the security level is Auth/Priv.
The confirm privacy password must be the same as the privacy password.
Confirm Privacy Password
ACL
Associate a basic ACL with the user to restrict the source IP address of
SNMP packets. You can configure to allow or prohibit SNMP packets
with a specific source IP address to allow or prohibit the specified NMS
to access the agent by using name of the associated user.
Configuring SNMP trap function
1.
Select Device > SNMP from the navigation tree.
2.
Click the Trap tab.
The trap configuration page appears.
Figure 98 Traps configuration
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module