H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 422)

401
Figure 408 Binding an AP radio to a wireless service
10. Enable 802.11n(2.4GHz) radio:
a. Select Radio > Radio from the navigation tree.
b. Select the box of the AP with the radio mode 802.11n(2.4GHz).
c. Click Enable.
Figure 409 Enabling 802.11n(2.4GHz) radio
Configuring the RADIUS server (IMC v3)
The following example uses the IMC (IMC PLAT 3.20-R2602 and IMC UAM 3.60-E6102) to illustrate the
basic configuration of the RADIUS server. Make sure a certificate has been installed on the RADIUS
server.
To configure the RADIUS server:
1. Add an access device:
a. Click the Service tab in the IMC Platform.
b. Select User Access Manager > Access Device Management from the navigation tree.
c. Click Add.
d. On the page that appears, enter expert as the Shared Key for authentication and accounting,
enter 1812 and 1813 as the port number for authentication and accounting, respectively,
select LAN Access Service as the service type, select H3C as the access device type, select or
manually add the access device with the IP address 10.18.1.1, and click OK.