Enabling 802.11n, Enabling wireless location – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 812
791
Figure 828 Binding the wireless service to a radio
Enabling 802.11n
1.
Select Radio > Radio from the navigation tree.
2.
Select the target AP.
3.
Click Enable.
Figure 829 Enabling 802.11n (2.4 GHz)
Enabling wireless location
1.
Select Advanced > Wireless Location from the navigation tree.
2.
On the page that appears, perform the following tasks:
a.
Select Enable for Location Function.
b.
Select Aero Scout for Protocol Type.
c.
Select Dynamic for Address Acquisition Method.
d.
Select Tag Mode and MU Mode for ap1, ap2, and ap3.
3.
Click Apply.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module