Adding an ipv6 acl – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 676

655
Table 213 Configuration items
Item
Description
ACL
Select the WLAN-AP ACL for which you want to configure rules.
Rule ID
Specify an ID for the rule.
If you do not specify the rule ID, the system will assign one automatically.
If the rule ID you specify already exists, the following operations modify the configuration
of the rule.
Action
Select the action to be performed for APs matching the rule:
•
Permit—Allows matched APs.
•
Deny—Drops matched APs.
MAC address
Set the MAC address range of APs.
MAC Mask
Serial ID
Set the serial ID of an AP.
Adding an IPv6 ACL
1.
Select QoS > ACL IPv6 from the navigation tree.
2.
Click the Add tab.
Figure 689 Adding an IPv6 ACL
3.
Configure the IPv6 ACL information, as described in
4.
Click Apply.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module