Configuring the wireless service, Configuring static rate limiting, Verifying the configuration – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 727: Network requirements
706
Configuring the wireless service
For the configuration procedure, see "
Configuring static rate limiting
1.
Select QoS > Wireless QoS from the navigation tree.
2.
Click Client Rate Limit.
3.
Select Inbound from the Direction list, and click
.
4.
Configure static rate limiting:
a.
Select Static from the Mode list.
b.
Enter 1024 in the Per-Client Rate field.
5.
Click Apply.
Figure 736 Configuring static rate limiting
Verifying the configuration
1.
Client 1 and Client 2 access the WLAN through the SSID named service1.
2.
Verify that traffic from Client 1 is rate limited to around 1024 kbps, so is traffic from Client 2.
Wireless service-based dynamic rate limiting
configuration example
Network requirements
As shown in
, wireless clients access the WLAN through a SSID named service2.
Configure all wireless clients to share 8000 kbps of bandwidth in any direction.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module