H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 117

96
Figure 57 Configuring the network time
3.
Configure system time parameters as described in
.
4.
Click Apply.
Table 38 Configuration items
Item Description
Clock status
Display the synchronization status of the system clock.
Local Reference Source
Set the IP address of the local clock source to 127.127.1.u, where u is
in the range of 0 to 3, representing the NTP process ID.
•
If the IP address of the local clock source is specified, the local
clock is used as the reference clock, and can provide time for other
devices.
•
If the IP address of the local clock source is not specified, the local
clock is not used as the reference clock.
Stratum
Set the stratum level of the local clock.
The stratum level of the local clock determines the precision of the local
clock. A higher value indicates a lower precision. A stratum 1 clock
has the highest precision, and a stratum 16 clock is not synchronized
and cannot be used as a reference clock.
Source Interface
Set the source interface for an NTP message.
If you do not want the IP address of a specific interface on the local
device to become the destination address of response messages, you
can specify the source interface for NTP messages so that the source IP
address in the NTP messages becomes the primary IP address of this
interface. If the specified source interface is down, the source IP
address of the NTP messages sent is the primary IP address of the
outbound interface.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module