Configuration guidelines, Configuration procedure, Figure 388 – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 648
627
•
AP 1 operates in normal mode and provides WLAN data services only.
•
AP 2 operates in monitor mode, and scans all 802.11g frames in the WLAN.
•
Client 1 (MAC address 000f-e215-1515), Client 2 (MAC address 000f-e215-1530), and Client 3
(MAC address 000f-e213-1235) are connected to AP 1. They are configured as friends.
•
Client 4 (MAC address 000f-e220-405e) is connected to AP 2. It is configured as a rogue device.
Figure 667 Network diagram
Configuration guidelines
•
The radio must be disabled so that the AP operation mode can be changed.
•
If you configure more than one detection rule, you need to specify the rogue device types (AP, client,
bridge, and ad hoc) and the rule matching order. For more information, see "
•
The wireless service configuration is needed for an AP operating in hybrid mode, and not needed
for an AP in monitor mode.
Configuration procedure
1.
Configure AP 1 to operate in normal mode:
In normal mode, AP 1 provides WLAN data services only. For information about how to configure
WLAN services, see "
2.
Configure AP 2 to operate in monitor mode:
a.
Select AP > AP Setup from the navigation tree.
b.
Click Add.
c.
On the page that appears, set the AP name to ap, select the AP model WA3628i-AGN, select
Manual, and enter the serial ID of AP 2.
d.
Click Apply.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module