Displaying the ipv4 active route table, Creating an ipv4 static route – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 209
188
Displaying the IPv4 active route table
From the navigation tree, select Network > IPv4 Routing to enter the page, as shown in
.
Figure 158 IPv4 active route table
Table 71 Field description
Field Description
Destination IP Address
Destination IP address and subnet mask of the IPv4 route.
Mask
Protocol
Protocol that discovered the IPv4 route.
Preference
Preference value for the IPv4 route.
The smaller the number, the higher the preference.
Next Hop
Next hop IP address of the IPv4 route.
Interface
Outgoing interface of the IPv4 route. Packets destined for the specified
network segment will be sent out of the interface.
Creating an IPv4 static route
1.
From the navigation tree, select Network > IPv4 Routing.
2.
Click the Create tab.
This manual is related to the following products:
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module