Logging in to the web interface – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 66
45
Logging in to the Web interface
You can use the following default settings to log in to the Web interface through HTTP:
•
Username—admin
•
Password—admin
•
IP address of VLAN-interface 1 of the device—192.168.0.100.
To log in to the device through HTTP:
1.
Connect the GigabitEthernet interface of the device to a PC by using a crossover Ethernet cable.
By default, all interfaces belong to VLAN 1.
The PC in this procedure is used for configuring basic device settings, and it is not necessarily the
PC you use for Web-based management.
2.
Configure an IP address for the PC and make sure the PC and device can reach each other.
For example, assign the PC an IP address 192.168.0.0/24 (excluding 192.168.0.100,
192.168.0.2 for example).
3.
Open the browser, and input the login information.
a.
In the address bar, type the IP address http://192.168.0.100, and press Enter.
The login page of the Web interface (see
b.
Enter the username admin and password admin, and click Login.
Figure 17 Logging in to the Web interface
c.
Select a country/region code from the Country/Region list, and click Apply.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module