Trace route operation – H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 281
260
Trace route operation
The Web interface does not support trace route on IPv6 addresses.
Before performing the trace route operations, execute the ip ttl-expires enable command on the
intermediate device to enable the sending of ICMP timeout packets and the ip unreachables enable
command on the destination device to enable the sending of ICMP destination unreachable packets.
To perform a traceroute operation:
1.
From the navigation tree, select Diagnostic Tools > Trace Route.
2.
Click the Trace Route tab.
The Trace Route configuration page appears.
Figure 234 Trace Route configuration page
3.
Enter the destination IP address or host name in the field.
4.
Click Start to execute the trace route command.
5.
View the result in the Summary field.
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module