H3C Technologies H3C WX3000E Series Wireless Switches User Manual
Page 602
581
Figure 609 Creating a wireless service
6.
Configure the wireless service:
a.
Expand the Security Setup area.
b.
Select the authentication type Open-System.
c.
Select the Cipher Suite option, and then select a cipher suite from the list as needed. This
example uses AES and TKIP.
d.
Select WPA and WPA2 as the security IE.
e.
Expand the Port Security area.
f.
Select the Port Set option, and then select the port mode userlogin-secure-ext.
g.
Select the Mandatory Domain option, and then select system from the list.
h.
Select the authentication method EAP.
i.
Disable the handshake, multicast trigger, and stateful failover functions.
j.
Click Apply.
A configuration progress dialog box appears.
k.
Click OK in the confirmation dialog box to enable the EAP service.
l.
After the configuration process is complete, click Close.
Figure 610 Wireless service configuration page
- H3C WX5500E Series Access Controllers H3C WX3500E Series Access Controllers H3C WX2500E Series Access Controllers H3C WX6000 Series Access Controllers H3C WX5000 Series Access Controllers H3C LSUM3WCMD0 Access Controller Module H3C LSUM1WCME0 Access Controller Module H3C LSRM1WCM2A1 Access Controller Module