H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 94)

73
Field Description
State
Current state of the AP:
• ImageDownload—The AP is downloading the version. If the
ImageDownload state persists, check the following: 1) The version of the
fit AP saved on the AC matches with the version that the AC requires; 2)
The space of the flash is enough.
• Idle—The AP is idle. If the Idle state persists, check the following: 1) If the
fields of Latest IP Address and Tunnel Down Reason are displayed as
-NA-, it indicates that the AP has never connected to the AC successfully.
You need to check the network cable, power supply of the fit AP, and the
AP serial number if the serial number was manually entered. 2) If the
fields of Latest IP Address and Tunnel Down Reason are displayed as
other contents, it indicates that the AP has connected to the AC
successfully. See the output of the Tunnel Down Reason field for the
detailed reason.
• Run—The AP is operating. It indicates that the AP has connected to the
AC successfully.
• Config—The AC is delivering a configuration file to the fit AP, and the fit
AP is collecting radio information through the radio interface and
reporting to the AC. This state is an instantaneous state.
Up Time(hh:mm:ss)
Time duration for which the AP has been connected to the AC. NA indicates
AP is not connected to the AC.
Model AP model name.
Serial-ID Serial ID of the AP.
IP Address IP address of the AP.
H/W Version Hardware version of the AP.
S/W Version Software version of the AP.
Boot-Rom version Boot ROM version of the AP.
Description Description of the AP.
Connection Type AP connection type: Master or Backup.
Peer AC MAC Address Peer AC MAC address in case of AC backup.
Priority Level AP connection priority.
Echo Interval(s) Interval for sending echo requests, in seconds.
Statistics report Interval(s) Interval for sending statistics messages, in seconds.
Cir (Kbps) Committed information rate in kbps.
Cbs (Bytes) Committed burst size in bytes.
Jumboframe Threshold Threshold value of jumbo frames.
Transmitted control packets Number of transmitted control packets.
Received control packets Number of received control packets.
Transmitted data packets Number of transmitted data packets.
Received data packets Number of received data packets.
Configuration Failure Count Count of configuration request message failures.
Last Failure Reason Last configuration request failure reason.