H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 521)

500
Item Description
Radio List
• Select the target radios from the Radios Available area, and then click << to add
them into the Radios Selected area.
• Select the radios to be removed from the Radios Selected, and the click >> to
remove them from the radio group.
Calibration operations
If RRM is not enabled, or the radio to be displayed works on a fixed channel, you can only view the work
channel and the power of the radio on the Operations tab in the Radio > Calibration page. Other
information such as interference observed and the number of neighbors is displayed when RRM is
enabled, that is, dynamic power selection or automatic dynamic frequency selection is enabled. For the
configuration of RRM parameters, see " Setting parameters ."
Displaying channel status
1. Select Radio > Calibration from the navigation tree.
2. On the Operations tab, click the Channel Status tab.
3. Click the desired radio to enter the page for displaying channel status.
Figure 533 Channel status
Table 160 Configuration items
Item Description
Channel NO Running channel.
Neighbor Num Number of neighbors on a channel.
Load (%) Load detected on a channel.
Utilization (%) Channel utilization.
Interference (%) Duration of all invalid packets detected on a channel.
Packet Error Rate (%) Error rate for packets on a channel.
Retransmission Rate (%) Retransmission rate on a channel.
Radar Detect Radar detection status.
Displaying neighbor information
1. Select Radio > Calibration from the navigation tree.
2. On the Operations tab, click the Neighbor Info tab.
3. Click the desired radio to enter the page for displaying neighbor information.