IDEC High Performance Series - Manual (Page 917)

WindO/I-NV2 User’s Manual 17-9
3 Preventive Maintenance Settings Dialog Box
17
Pr
ev
entiv
e Mainte
nanc
e Function
■ Level 2
Select this check box to configure the level 2 threshold and report device.
■ Level 3
Select this check box to configure the level 3 threshold and report device.
●
Operation Count Tab
The Operation Count tab is used to configure the destination device for the counted operation count and the report
conditions when the threshold is reached or exceeded.
■ Measure Operation Count
Select this check box to count the operation count.
Report Device: Specifies the bit device or bit of the word device for reporting when the operation time reaches
or exceeds the level 1 threshold.
Click
to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Threshold Specifies the time as a constant or a device that is the criterion for reporting at level 2. For a
constant, the range that can be set varies based on the data type. For a device, click
to
display the Device Address Settings dialog box. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Report Device: Specifies the bit device or bit of the word device for reporting when the operation time reaches
or exceeds the level 2 threshold.
Click to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Threshold Specifies the time as a constant or a device that is the criterion for reporting at level 3. For a
constant, the range that can be set varies based on the data type. For a device, click
to
display the Device Address Settings dialog box. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Report Device: Specifies the bit device or bit of the word device for reporting when the operation time reaches
or exceeds the level 3 threshold.
Click to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
(Operation Count Device): Specifies the destination device for the counted operation count. You can only specify an
HG keep register (LKR).
Click
to display the Device Address Settings dialog box. For the device address
configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
If you specify the same device as the operation count device for multiple numbers, the counted operation
count is added in total by all the monitored devices for each number and the function will not be able to
count normally.