IDEC High Performance Series - Manual (Page 1170)

2 Web Server Function (HG3F/4F)
27-12 WindO/I-NV2 User’s Manual
2.1 Web Server Function Overview
The web server function is a function to remotely perform HG3F/4F maintenance using a web browser terminal such
as a computer or PDA. The following functions can be used just by configuring the Ethernet settings.
• Monitoring
• Displaying the alarm log
• Displaying the data log
• Reading and writing to the CF card
• Device Monitor
2.2 System Configuration
An example system configuration for using the web server function is shown below.
Configure the HG3F/4F Ethernet settings (IP address, netmask, default gateway) and connect to a local network.
(1) Access the HBodyBold_NumlistG3F/4F from a web browser terminal connected to the local network to use the
web server function.
(2) When the lBodyBold_Numlistocal network is connected to an external network, configure the web browser
terminal connected to the remote network with the local network’s gateway, router, and other settings. Access the
HG3F/4F from the remote web browser terminal to use the web server function. For gateway, router, and other
settings, contact the administrator of the network the HG3F/4F is connected to.
2 Web Server Function (HG3F/4F)
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
Web Browser Terminal
(Computer, PDA, etc.)
Web Browser Terminal
(Computer, PDA, etc.)
Local Network Ethernet Communication (TCP/IP)
Remote Network
(1)
(2)
External Network
HG3F HG4F HG3F HG4F
External device
MICRO/I
External device
MICRO/I
Both the HG2G-5F, HG3G/4G and HG3F/4F can exist on the same local network.
When accessing the HG2G-5F, HG3G/4G to use the web server function, refer to “1 Web Server Function
(HG2G-5F, HG3G/4G)” on page 27-1.