IDEC High Performance Series - Manual (Page 893)

WindO/I-NV2 User’s Manual 15-11
3 Operation Log Settings Dialog Box
15
Oper
ation Log Function
■ Monitor Number of Stored Data
Select this check box to count the amount of recorded Operation Log data. The amount of recorded data is written to
the specified device.
■ Monitor % Space Used in Data Storage Area
Select this check box to monitor the usage of the data storage area allocated as the save destination for Operation
Log data. The usage is calculated from the data storage amount allocated to the data storage area and the amount of
saved data, and then written to the specified device.
Usage = Current amount of Operation Log data ÷ Operation Log data storage amount (omits values after the decimal point)
■ Clear Log Data
Select this check box to erase the Operation Log data saved in the data storage area.
■ Number of Stored Data
Shows the maximum amount of Operation Log data to save in the data storage area. Data is saved up to the set
amount. The maximum amount of data that can be saved in the data storage area is listed next.
■ Trigger Condition
Selects the trigger condition for the Operation Log function.
*1 Advanced mode only
(Destination Device): Specifies the destination word device.
For the device address configuration procedure, refer to Chapter 2 “5.1 Device Address
Settings” on page 2-67.
Report when Number of Stored Data has reached or exceeded Threshold
*1 :
Writes 1 to the report device when the current amount of data reaches or
exceeds the set threshold.
Threshold *1 : Specifies the amount of data that is the basis for reporting.
HG2G-S/-5S: 1 to 3945
HG2G-5F, HG3G/4G: 1 to 8330
Report Device *1 : Specifies the destination bit device or the bit in the destination word device.
For the device address configuration procedure, refer to Chapter 2 “5.1
Device Address Settings” on page 2-67.
(Destination Device): Specifies the destination word device to write the current usage of the amount of Operation
Log data storage.
For the device address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings” on
page 2-67.
Report when % Space Used has reached or exceeded Threshold
*1 :
Writes 1 in the report device when the current usage reaches or exceeds the
set threshold.
Threshold *1 : Specifies the usage (1 to 100) that is the basis for reporting.
Report Device *1 : Specifies the destination bit device or the bit in the destination word device.
For the device address configuration procedure, refer to Chapter 2 “5.1
Device Address Settings” on page 2-67.
(Trigger Device): Specifies the bit device that triggers the erasure of the data. The saved data is erased when the
value of the configured device changes from 0 to 1. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
HG2G-S/-5S: 3,945
HG2G-5F, HG3G/4G: 8,330
Click to open the Data Storage Area Management dialog box where you can change the allocation of data storage
area memory. For details, refer to Chapter 16 “Data Storage Area” on page 16-1.
Always: Always records events.
Device: Records events when the specified device is 1.
For the device address configuration procedure, refer to Chapter 2 “5.1 Device Address Settings”
on page 2-67.