IDEC High Performance Series - Manual (Page 1271)

WindO/I-NV2 User’s Manual 30-27
2 USB Flash Drives
30
External Memory Devices
●
Uploading a project file
Uploads the project file (ZNV format) used to operate the MICRO/I and saves it to a USB flash drive or an SD memory
card.
When the upload is complete, the MICRO/I will reset and start over at the beginning of the project.
●
Downloading a PLC program file
Downloads a PLC program file (ZLD format) saved on a USB flash drive or an SD memory card to the PLC connected
to the MICRO/I.
HG3G HG2G-5F HG4G
Save Upload
Computer
Project file
(ZNV format)
USB Autorun
definition file
(hgauto.ini)
SD Memory
Card
USB flash drive
MICRO/I
Refer to Chapter 28 “1 Project Transfer Function” on page 28-1 for important notes and limitations.
HG3G HG2G-5F HG4G
Save
Save
Download
PLC Computer
SD Memory
Card
USB flash drive
MICRO/I
PLC program file
(ZLD format)
PLC program file
(ZLD format)
USB Autorun
definition file
(hgauto.ini)
Refer to Chapter 28 “2 PLC Program Transfer Function” on page 28-20 for compatible PLCs, important notes,
and limitations.