IDEC High Performance Series User Manual

Page 880

4 Using the Data

14-42

WindO/I-NV2 User’s Manual

Specify the source device for the copied data in Display Device under Display Method.
For sequential devices of the amount of data to copy starting with Destination Device configured on the Options
tab on the Data Log Settings Individual Settings dialog box, set Display Device for each Numerical Display to
those devices.
Example: When Destination Device is LDR 10, Number of Data is 3

Specify three Numerical Displays with Display Device specified as LDR 10, LDR 11, LDR 12

Click

to display the Device Address Settings dialog box. For the device address configuration procedure, refer

to Chapter 2 “5.1 Device Address Settings” on page 2-67.

Click OK.
The Properties dialog box closes.

Repeat step

through

to configure the Numerical Displays for the amount of data to copy.

This concludes configuring the Numerical Display.

HG3G

HG2G-5F

HG2G-5S

HG2G-S

HG4G

MICRO/I

Host

(Internal device)

124

125

126

Data Log data

Sampling

Time

Data001

01/01/2011