Commands – IDEC High Performance Series User Manual
Page 741
WindO/I-NV2 User’s Manual
12-5
1 Bit Write Command
12
Commands
■
Destination Device
Specify the destination bit device.
Click
to display the Device Address Settings dialog box. For the device address configuration procedure, refer
to Chapter 2 “5.1 Device Address Settings” on page 2-67.
■
Write
Specify the number of bit devices (1 to 64) at the destination.
This setting is enabled only if Action Mode is set to Set or Reset.
Example:
This fills a contiguous block of bit devices with the same value.
If the bit in a word device is specified, the same value is written to same bit of contiguous word devices.
■
Source Data
Specifies the device where the data to be written is stored.
This setting is enabled only if Action Mode is set to Move.
Example:
This button writes the values in a contiguous block of bit devices to a contiguous block of devices at the
destination.
*1 Advanced mode only
Toggle:
Toggles the value of the specified bit device when the trigger condition is satisfied.
If the value of the bit device is 0 it changes to 1, and vice versa.
Move:
This function writes the value in the source bit device to the value in the destination bit device
when the trigger condition is satisfied.
State of condition
Action
Toggle
Toggle
Condition
Condition
Condition
Condition
Satisfied
Satisfied
Satisfied
Not satisfied
Not satisfied
Not satisfied
Satisfied
Satisfied
Satisfied
Not satisfied
Not satisfied
Not satisfied
State of condition
Action
Move
Move
Condition
Condition
Condition
Condition
Satisfied
Satisfied
Satisfied
Not satisfied
Not satisfied
Not satisfied
Satisfied
Satisfied
Satisfied
Not satisfied
Not satisfied
Not satisfied
1
M0
1
M1
1
M2
1
M3
1
M4
Action Mode: Set
Write: 5
Destination Device: M0
Condition
Satisfied
Satisfied
Satisfied
Condition
bit
bit
15
0
Satisfied
Satisfied
Satisfied
1
D0
D1
D2
D3
D4
1
1
1
1
Action Mode: Set
Write: 5
Destination Device: D0-15
Device:
Specify the source bit device.
Click
to display the Device Address Settings dialog box. For the device address configuration
procedure, refer to Chapter 2 “5.1 Device Address Settings” on page 2-67.
Transfer:
Specify the number of bit devices (1 to 64) to move.
1
LM0
0
LM1
0
LM2
1
LM3
Device: LM0
Transfer: 4
Destination Device: M0
1
M0
0
M1
0
M2
1
M3
CondiƟon
Satisfied
Satisfied
Satisfied