IDEC High Performance Series - Manual (Page 470)

9 Potentiometer
8-146 WindO/I-NV2 User’s Manual
9.1 How the Potentiometer is Used
Writes a value to a word device by pressing a slider button.
• The slider display position increases and decreases while the button is depressed. The value of the slider at the
displayed position is written to the device when the button is released.
The slider indicates the value written to the device. When the value is increased or decreased, the slider display
position also changes.
The slider moves between a user-defined minimum and maximum value.
The input value increases and decreases while the button is depressed. The value of the slider at the displayed
position is written to the device when the button is released.
9 Potentiometer
HG3G HG2G-5F HG2G-5S HG2G-S HG4G HG1F HG2F HG2S HG3F HG4F
D0 : 0
Value of slider at
displayed position
105
127
Value of slider at
displayed position
D0 : 127
MICRO/I
D0 :
Value of slider at
displayed position
0
Host device
0
Write to device
Default state Press R-button Release Press L-button Release
Operation
and view
Slider Stop Moves right Stop Stop Moves left
Value Increases Decreases
Action Write Write
The slider display position does not change when the destination device value changes unless it was
changed by the Potentiometer buttons. However, immediately after the screen is switched and immediately
after the part is displayed on the screen, the slider is displayed at the position specified by the destination
device value.